Water tank should pay attention to things

Water tank pots high speed and low speed different treatment

After the tank is opened, the speed of the tank is different depending on the treatment method. When the water tank is opened at a low speed, immediately stop the engine and turn off the engine. In the case of avoiding burns, turn the engine cover open to dissipate heat, and then call for assistance.

If the engine is running at a high speed before the pot is opened, remember that the engine cannot extinguish the fire but allow the engine to idle for a while. The engine is in high-speed operation, and the heat generated is not yet completely emitted. It will generate high temperatures, causing parts to be deformed and damaged, and residual cooling water can help the heat to escape.

Some owners have discovered that the vehicle will be splashed with water to cool down after the vehicle is opened. This method should also be handled according to different circumstances. If it is caused by dirty water, electronic fan failure, or overheating of the radiator, the large circulation is turned on. The water can be poured on the radiator to cool the radiator.

It should be noted that the water is poured on the radiator of the engine radiator instead of being poured on the engine. The surface temperature of the engine is very high. If it is suddenly poured onto the surface with cold water, the engine surface will be deformed due to local cooling, and the relevant components will be deformed. There are many sensors on the water, pouring water will short circuit electrical components.

Water temperature is too high or thermostat failure

“After parking for a period of time, after the water temperature reaches normal temperature, the owner can check whether the tank cooling water is normal and whether there is any leakage in the water tank or water pipe. If no abnormalities are found through inspection, the cooling water can be made up and continue driving.” Remind you that when you drive again, the owner needs to be aware that if the temperature of the water rises above the normal value, it may be the thermostat failure. The owner can choose to drive slowly, and it is necessary to pay attention when driving. Once the water temperature is too high, the engine is naturally cooled by parking.

“Xiagong Chusheng (Hubei) Special Purpose Vehicle Manufacturing Co., Ltd. reminds you not to immediately open the water tank cover to make up water after boiling. At this time, the temperature and pressure of water in the water tank are very large. Immediately opening it may cause high-temperature steam to blow out, causing an accident. “Hubei Cheng Li reminds you that it is best for the owner to wait for a while before opening the water tank and opening the tank lid to prevent water vapor from being burned.

In addition, do not add ice water when the water temperature in the tank is still high. Because the added ice water will cause the engine to cool quickly, this thermal expansion and contraction will destroy the normal gap between the internal parts of the engine, accelerate the wear between the parts, and damage the engine. It is best to wait until the cooling water in the tank is completely cooled before adding cold water.

Insulating Glass Sealing Robot

Insulating Glass Sealing Robot include three section:input section,sealing section,output section.Machine used to seal double glazing,triple glazing or step glazing.Automatic sealing robot adopt friendly man-machine interface which is concise and more convenient to operate.

Insulating Glass Sealing Robot with 2000mm*3000mm,2500*3500mm model.We also can produce machine according to your specific size.

Automatic Insulating Glass Sealing Robot,Manual Sealing Machine,Insulating Glass Sealing Robot,Double Glazing Sealing Machine

JINAN WEILI MACHINE CO LTD , https://www.wlglassmachine.com

Posted on