First, the internal circulation switch is closed for a long time, which causes the cooling effect to decrease.
The following figure shows the inner cycle switch. If the owner accidentally turns off the internal circulation switch, it means that the air conditioner enters the external circulation state, and the outside air enters. If it is in the external circulation state for a long time, the dust in the outside air will enter the air circulation, and the evaporator is easily polluted, which is not conducive to cooling.
Second, the leakage of snow species, causing cooling down and adding snow species can not be done casually. Because the snow does not evaporate, its pressure will increase with the increase of temperature. For example, the snow pressure is 4-5 kg ​​in the winter, but it can reach 8-9 kg in summer when the snow is high. When the pressure becomes larger, even if there is a slight crack in a certain air-conditioning duct component, the snow species will leak, so the leakage of the snow species is for a reason.
Third, the condensing network dust, affecting the cooling effect of the car for a long time, cooling the Internet will be covered with dust, in this case, the owner just pay attention to the car wash, use the tap to clean the dust condensation network, you can solve this problem.
Fourth, air-conditioning compressor failure, causing cooling down Compressor most of the failures are from external collisions, because the life of the compressor is generally very long, if the general normal travel 30,000 kilometers per year, the compressor life can reach 20-30 million Therefore, a good compressor will not be damaged for 10 years. The manufacturer's warranty policy for the compressor is two years or 60,000 kilometers.
Understand the causes of these automotive air conditioning faults, and quickly check what's wrong with your car's air conditioner! If it is not the above reason, go to the repair shop to see it!
Alluvial Gold Dressing Equipment
The STL water-jacketed Gold Concentrator is a kind of gravity separation equipment. It was developed by Changchun Gold Research Institute Co., Ltd. in 1985 and entered the market. At present, it has been used in many domestic and foreign companies. It is suitable for the recovery of single gold in placer gold, vein gold mines and polymetallic mines, instead of mercury plate operations. The addition of large single gold particles in the collected ore before flotation can further increase the recovery rate of gold mines, and it can also be used from gold-bearing mines. Separate single gold from flotation gold-copper concentrate and flotation gold concentrate.
The main indicators of this series of equipment basically reach the level of similar international products (such as Nielsen gold selectors, etc.). Compared with similar equipment at home and abroad, this series of equipment has the advantages of high cost performance, easy operation, and low maintenance costs.
Alluvial Gold Dressing Equipment,Alluvial Gold Mining Equipment,Gold Extraction Process,Alluvial Gold Equipment
Changchun Gold Research Institute Co.LTD , https://www.changchungoldresearch.com