Tyre inflation should be standardized

Tyre inflation should be standardized

1, inflate should pay attention to safety. Always check the air pressure with a barometer to avoid over-inflating and bursting the tires. Replacement of new contents for tire filling Nitrogen = comfort + fuel-saving to the owner of the trick: buy "low-carbon" tires 2. After stopping driving, wait for the tire to cool before re-inflating, as the temperature of the tire when the vehicle is moving will increase, affecting the pressure .

3, check the valve. If the valve stem and the valve core do not match with each other, there are protruding recesses and other defects, and it is inconvenient to inflate and measure the air pressure.

4, inflate should pay attention to clean. The filled air must not contain moisture and oil to prevent deterioration of the inner tube rubber.

5, when the inflation should not exceed the standard air pressure after the release of deflation, can not be too long after the out inflated and over inflated, if more than the standard will lead to excessive expansion of the cord, causing its strength to reduce impact The life of the tire.

6, before filling the valve should wipe the dust on the mouth, do not loosen the valve core, after the completion of the application of soap bubble water (or saliva) painted on the valve, check for leaks (if the leak will produce small bubbles) , And valve caps are tightly fitted to prevent sediment from entering the interior of the valve.

7. When the radial tire is inflated, due to structural reasons, the amount of sinking and grounding is large, and it is often mistaken for insufficient inflation and overinflation; or vice versa, because the amount of sinking and grounding area is larger. In the absence of air pressure, it is also mistaken for sufficient. Apply a standard barometer to measure. The radial pressure of the radial tires should be 0.5-1.5kg/cm2 higher than that of ordinary tires.

8. The barometer used in the car or the barometer used between the tires should be calibrated regularly to ensure accurate pressure check.

Product Name: Electrical Stainless Steel Tube Belt Polisher
1. This machine make it incredibly fast and easy to finish closed or open tube forms, such as railings, etc.
2. With different belts, you can rough sand and fine sand to remove surface imperfections,
blend,create surface effects like stain or brush finished. All the way to mirror polishing.
3. The arms allow the belt to wrap around the surface to sontact 180 degrees of the tube at a time.
4. There's no easier or faster way to deal with tube constructions.
5. Humanity designed handle
6. The powerful Marathon motor supply inexhaustible power
7. VTC full-ware electronic speed control, makes the machine maintain stable high speed under a heavy load
8. Attached the Ground Fault Circuit Interrupter
9. Variable speed, constant power
10.Extermal carbon brush, easier to replace

11.Precisely guiding of belt, especially be applied for evenly polishing

Stainless Steel Polishing Machine

Stainless Steel Polishing Machine,Portable Stainless Steel Polishing Machine,Stainless Steel Easy Polishing Machine,Stainless Steel Automatic Polishing Machine

Shandong Hightop Machinery Co,.Ltd , http://www.hightopmachinery.com