Troubleshooting double glass reactor

Double glass reactor can provide high temperature reaction (maximum temperature can reach 300 °C); double glass reactor can also be low temperature reaction (lowest temperature can reach -80 °C); double glass reactor can be evacuated, In order to do a vacuum reaction. Moreover, its unique design makes the test safer and more convenient.
Operational process considerations  
1. The operation and maintenance personnel of the double glass reactor should remove the hard objects such as watches and rings when operating or repairing, so as to avoid damage to the glass parts, especially the diamond ring can cause fatal damage to the glass fittings. hurt.
2. Strictly abide by the provisions on cooling, oil filling and other aspects of the product instruction manual, and do a good job of equipment maintenance and maintenance;  
3, the electrical control instrument should be operated by a person, and set overload protection facilities as required.  
4. When all valves are used, slowly rotate the valve stem to close the cover to achieve the sealing effect. It is not easy to use excessive force when closing, so as not to damage the sealing surface;  
5. When using, operate and use strictly according to the working pressure and working temperature calibrated on the product nameplate to avoid danger.
Troubleshooting
1. Turn on the power switch and the indicator light is off. The external power supply is not connected or the contact is bad. Please professional electrician to check the power supply and socket.
2. Short-circuit the fuse. Set the power switch to the OFF position and replace the fuse.
3. The power indicator is on but not rotating. The rotary shaft is rusty and stops using, and the supplier is contacted with the motor. The electrical box fault is not connected with the seven-pin plug, and the seven-pin plug is reconnected.
4. The vacuum suddenly disappears, the glass is cracked, the switch is broken, check the glass parts, and switch the switch.
5. There is a vacuum, but not on the seal ring wear, connect the vacuum switch leakage, replace the seal ring, switch.
6. There is sometimes no vacuum, there is loose dirt connector on the steel shaft, please remove the dirt Check vacuum gauge, vacuum pump.
7. The vacuum hose is aging. Please replace the vacuum hose.
8. The main shaft of the main shaft is loosened, and the tight top screw is loosened and tightened.
10. If the motor temperature is too high and the motor is over-powered, turn the shaft by hand to check if it is heavy. Remove dirt from the contact area between the seal ring and the glass shaft and apply vacuum Grease.
11. The speed display is inconsistent with the actual situation, the voltage is not stable, there is error in itself, and contact with the supplier.
12. The shell is energized and the heating pipe is cracked into the water. Please have a professional electrician check it.

Automotive Grease

Bearing Grease,Lithium Grease,Aluminum Grease,Lithium Soap Based Grease

AMER TECHNOLOGY CO.,LTD. , https://www.amerlube.com

Posted on