2, the pump is not suitable for conveying dirty oil, so the filter should be set at the end of the inlet.
3. There is no safety valve in the pump. It is recommended to install a safety valve in the oil discharge pipeline to ensure the safe operation of the system.
4. The right shaft coupling should be coaxial. After the installation is completed, the shaft coupling can be operated smoothly without any negative pressure.
5, the unit should be installed on the level of cement foundation, fixed with anchor bolts.
6, the installation height of the pump does not exceed the allowable suction height.
2CY gear oil pump is used to transport lubricating oil in the lubrication system in various mechanical equipment.
Working principle 1. The pump is not suitable for conveying dirty oil, so an oil filter should be installed at the inlet pipe end.
2. There is no safety valve in the pump. It is recommended to install a safety valve in the oil discharge pipeline to ensure the safe operation of the system.
3, the pump steering regulations: From the pump to the motor, the direction of rotation is counterclockwise.
4, the unit should be installed on the level of cement foundation, fixed with anchor bolts.
5. The installation height of the pump shall not exceed the allowable suction height.
6. The right shaft coupling should be coaxial. After the installation is completed, the shaft coupling can be smoothly operated without negative pressure. The pump is a volumetric pump, the main and the passive gears and the pump body, the left and right pump cover are composed of two closed spaces for oil inlet and outlet. When the gear rotates, the volume of the inlet cavity is continuously decoupled due to the meshing teeth. Bigger. Vacuum is formed and the liquid is sucked in. There is a valley of teeth to the oil chamber, and the volume of the oil chamber is greatly reduced due to the continuous engagement of the meshing teeth, and the oil is discharged by being compressed so as to achieve the purpose of conveying the oil. Edit this paragraph structure that this series of pumps mainly by: left and right pump cover, pump body, the main, passive gear shaft, bushings, oil seals and other parts.
Paint stop filter media
This filter media is made of long fiber glass with gradual density. Inlet side is green, and outlet side is white. Other names: floor filter, fiberglass media, paint arrestor media ,Paint Collection Filter) is constituted by long-fibre fibreglass stiffened with synthetic resins. These filters enable better dust retention, with a higher accumulation capacity.
Our filtering media is self-extinguishing in Class F1 DIN 53438 and can cope with temperatures of up to 120ËšC. The media cannot be regenerated and, therefore, must be disposed of at the end of its operating life. Resistant to solvents and chemical products, it is used as an exhaust filter for coating booths and as a pre-filter in air-treatment units.
It is supplied in rolls of up to 20 metres in length, of various heights, and in panels.
High separation efficiency
Different color on inlet and outlet side
Flexible
Economical and practical
Application: Used in the spray booth or filter mist in the kitchen
Type: Supply slices or rolls size
Media: Fiber glass with gradual density, inlet side is green colour, outlet side is white
EN779 class: G3, G4
Average arrestance: 93%ASHRAE52.1-1992
EUROVENT4/5 class: EU3, EU4
Average separation efficiency: 95%
Final resistance: (suggest) 130Pa-200Pa
Temp. Resistance: 170
Paint Stop Filter Media,Ps-100 Paint Stop,Ps-50 Paint Stop,Fiberglass Paint Stop,Roller tape filter media glass,Glass filtration media,Coalescer media
Hebei Fangyu Trade Co., Ltd. , https://www.laderytrading.com