The following describes a simple method of finding faults—the truncation method. This method finds the fault location based on the gas system schematic diagram.
The “truncation method†refers to the system that first finds the fault on the schematic when a fault occurs. Then from the central part of the system, “cut off the waist,†determine the half of the fault through the test method. This will eliminate half of the system at once, and then in the remaining half of the system, find the middle part of the cut test to determine where the fault is. Half of the way, the faulty part can be found accurately in a short time, and the fault location can be found out and then dismantled.
For example, after stepping down the main brake valve, the (middle) rear axle brake sub-chamber does not act such a fault. First, find the (middle) rear axle brake system and the components associated with the system from the schematic diagram. The (middle) rear axle brake system consists of air compressor, pressure regulator, oil-gas separator, four-circuit protection valve, air reservoir, main brake valve load control valve, relay valve and compound brake chamber. First, select the middle part of the system, for example, select the main brake valve 12 outlet port “21â€, and disassemble the “21†joint, step on the brake pedal, such as “21†interface gas, indicating that the main brake valve before the system components are not problem. Reconnect the connector, and then select an intermediate part of the remaining system, such as the relay valve 16 outlet port "2", disconnect the connector, step on the brake pedal, observe the gas outlet "2". If there is no pressure output, it means that the fault is between the load regulating valve 15 and the relay valve 16. Then disconnect the air outlet “2†of the load regulating valve 15, step on the brake pedal, and observe the interface “2â€. If there is no pressure output at this time, it means that the fault is in the load regulating valve 15 .
The above only exemplifies the application of the “truncation methodâ€. Using this method plus practical experience, it will be applied freely in practical work and achieve a multiplier effect.
Aluminium coil manufacturer, standard width 500-1750mm, can provide special size. Thickness from 0.2mm to 10mm or higher. Aluminium alloy code can be 1050, 1060, 1070, 1100, 1235, 3003,3105, 5052, 5083, 8006, 8011 etc. The aluminium coil roll which we produced for many application like construction, electronics, automotive, pharmaceutical, food service, manufacturing, transportation, and so on.
After milling, welding, heating, inspection and cleaning, the aluminium coil is finished. We will pack carefully to ensure that the products in the hands of customers are perfect.
Aluminium Coil,Aluminium alloy Coil,Aluminium Coil Stock,Aluminium Coil Price,aluminium casting coil
Trumony Aluminum Limited , https://www.szaluminumplate.com