Yunnei Power: Resolution of the First Extraordinary General Meeting of Shareholders in 2012

The first temporary shareholders' meeting of Yunnei Power in 2012 was held on March 19th, 2012. The meeting adopted the on-site voting. The meeting was convened by the company's board of directors and chaired by Chairman Li Yingkun. Some directors, supervisors and senior executives of the company attended the meeting.

The meeting reviewed and approved the proposal to supplement the fourth session of the board of directors of the company. It is agreed that Mr. Yang Bo will be added as a director of the fourth session of the company's board of directors. The term of office will run from the date of approval at this extraordinary general meeting of shareholders to the expiry date of the fourth session of the board of directors. The independent directors of the company issued independent opinions on the addition of Mr. Yang Bo as a director of the fourth session of the company's board of directors.

Stainless Steel Clip

Clips and Fasteners are most commonly categorized as flat or sheet material that is formed into simple or complicated shapes. Most often, Clips and Fasteners are manufactured using both low and high carbon steels, depending on the application. In some applications, high carbon spring steels are utilized where a spring force is required that cannot be obtained with normal spring forces. When high carbon spring steels are used for manufacturing, it is a standard requirement that the product is heat treated and quenched to a hardness level that allows the product to flex without deforming. Heat treating and oil quenching are commonly used for the hardening process, but an Austemper heat treating process is typically the best practice for eliminating heat treat deformation.

Steels most commonly used in our process for manufacturing Clips and Fasteners are either low carbon, cold rolled steel (without heat treatment), and high carbon spring steels ranging from Grade 1050 to 1095, along with Stainless Steels and precious metals such as Brass, Phosphor Bronze, and Beryllium Copper. Clips and Fasteners that we manufacture typically range in material thickness of .010″ up to .080″, with many of our prototype and short run orders ranging from these sizes. We also have the capability of manufacturing designs in a wide range of shapes and sizes. We can supply Clips and Fasteners with a variety of special finishes or coatings to your specification along with various heat treating requirements.

Clip Materials

Material	Grade	Specification
High Carbon Spring Steel Strip	1050	ASTM A682 (AISI 1050)
	1065	ASTM A682 (AISI 1060)
	1070	ASTM A682 (AISI 1070)
	1074	ASTM A682 (AISI 1074)
Stainless Steel Strip	301	ASTM A666
	302	ASTM A666
	316	ASTM A582 (AISI 316)
	17-7 PH	ASTM A693 (631) (AMS 5529)
Non-Ferrous Alloy Wire	Phosphor Bronze	ASTM B103
	Beryllium Copper	ASTM B194
High Temperature Alloy Wire	Inconel 600	ASTM B168 (AMS 5540)
	Inconel x750	AMS 5542
Low Carbon Steel	Cold Rolled Steel (CRS)	ASTM A1008 (AISI 1008/1010)

Spring Steel Clip,Stainless Steel Clip,Spring Clip,Stainless Clips

Nanpi Jian Tong Hardware Manufacturing Co., Ltd. , https://www.sheetmetals.nl