![<?echo $_SERVER['SERVER_NAME'];?>](/template/twentyseventeen/skin/images/header.jpg)
The National IV Dongfeng Ruiling Medical Waste Transfer Vehicle, the National IV emission standard, adopts the Dongfeng Ruiling Class II cargo carrier, model DFA1041SJ35D6. The engine uses the D28D10-4DA, 75-power/102-hp diesel engine produced by Dongfeng Light Engine Co., Ltd. Cab with rollover, single row cab, cab with direction assistance, clutch booster, front axle 2 tons, rear axle 4 tons, wheelbase 3300, tire 7.00R16 wire tire.
Body introduction: the body is fully enclosed, the back door is a double sealed structure (set the double back door and the inner door two doors, a gas spring is set on the inner door to facilitate the opening of the inner door up and down) to ensure that the inside of the box is filled with rubbish The partition of medical treatment and the outside world also facilitates the loading and unloading of goods. The stainless steel plate inside the body is used for the inside wall, and the corrosive disinfectant is resistant to acids and alkalis. Arc stainless steel and corners are arranged around the inside of the compartment. There is no clear corner for disinfection and cleaning. .
L-type compartment: The medical waste transfer car compartment is divided into the cargo loading compartment and the medical article storage compartment. A single-side door is set outside the medical article storage compartment (the assistant driver) to facilitate the storage of medical and medical equipment to ensure the safe storage of medical waste. And the personal safety of staff.
Automatic spraying device (optional): The medical waste transfer body can be equipped with an automatic spraying device. The automatic spraying control system is set in the cab or in the compartment where the medical device is placed, for the type of the disinfecting solution and the spraying time. The requirements of the spray time setting adjustment (10S-5min), the use of automatic spraying device, spraying the disinfectant can quickly kill a variety of microbial bacteria in the cabin, so that transport and handling more secure and reliable.
Contact Tel 0722-3821899 Contact, Zhou Zhongxing http://
Http :// WWW . HBCL99 . COM
Sales Hotline: 15897596858
Office Phone: 0722-3821899
E-mail:
SKYELEC Heater Rod Thermostats are suitable for use with Single Phase to control heating in electroplating baths.They are equipped with a 1.6 metre supply cord and standard red cap terminal casing.
The temperature control probe is suitable for automatic control of a pre-set value in the process media and are suitable for heaters up to 2.3 kw single phase. For higher loads, or three phase heaters an additional contactor should be used.
The probes construction makes it ideally suited for etch, pickle and plating solutions. Its robust construction and chemical resistance ensures a long service life. To set the rod thermostat, unscrew the red cover which provides access to the temperature setting control knob. Turn until the desired temperature is opposite the arrow.
Suitable for use with single phase to control heating of electroplating baths and similar solutions.
Comes complete with heavy duty terminal box and adjustable mounting blocks ready for connection.
Available in: Stainless steel, Titanium, Mild Steel or PTFE.
Alternative lengths are available to order.
The units incorporate an integral 25 amp rated thermostat unit housed with a chemically resistant, PVC coated steel terminal box, complete with quick fix brackets.
The thermostat opens on a rising temperature. Range: 25°C to 100°C. They are suitable for up to 6 kw heaters on a single phase supply. For higher loads or a three phase supply an additional contactor should be used.
The control knob is situated outside the PVC coated terminal box.
PT100 Temperature Control, Heater Rod Thermostats, Electroplating Temperature Control
Guangzhou Quanxu Technology Co Ltd , https://www.silicamattingagent.com