What are the precautions for car washing a motorcycle?

If you ride a rider, the car that travels frequently in the urban and rural national roads will be very dirty, mainly after the rain. If you are dirty, you have to wash your car. Otherwise, your car will be terrible. Car washing is also an essential skill for riding a friend.

The sealing performance of motorcycles cannot be compared with cars. Don't be forced to go to the car wash shop or let others help wash the car. The car wash shop seems to have a complete set of operating specifications. In fact, the car wash shop uses a high-pressure water gun to wash the motorcycle. There will be many safety hazards. If it is not good, the cremation plug and various lines will be faulty. The pressure of the high-pressure water gun is too high, and the car wash water is easy. Splashing into the body harness package causes a short circuit.

The wiring harness of the new car is better sealed, so don't worry. For a long time, the body line, the car wire harness seal due to the natural aging of the material, there will be many cracks and cracks that are difficult to check. At this time, washing the car with a high-pressure water gun will bring great safety hazards to the car. There is also the need to cool the hot car and wash it again when washing the car, suddenly flushing the engine, exhaust pipe and other components with cold water, the consequences are very serious. The principle of thermal expansion and contraction is clear that it will destroy the oil seal of various parts, causing the engine to seep. Many of the rider's engine is slightly oily. This is caused by the reason, and it also causes the rhodium layer at the junction of the exhaust pipe and the engine. Peel off oxidation rust.

Old cars must be treated more carefully when washing cars, headlights, left and right handrails, electric doors, exhaust pipe exhausts (preferably plugged with things), speakers, cremation plugs, air filters, batteries, etc. Flushing, these parts have circuits. If they are wet, they will cause short circuit or electric leakage. If the lights are not bright, the speakers are not ringing, they are not on fire, the driving is weak, and the contact is bad, it is best to scrub with a rag. After the car wash, the whole car should be as soon as possible. Dry with a dry rag, especially electric clocks, instruments, left and right handrails, cremation plugs, fuel tank caps and other important parts. Pay special attention to take the cremation cap and take a few times to pry out the water in the upper casing. Otherwise, it will affect the ignition. After drying, start the vehicle as soon as possible. The support frame will run for 5-10 minutes, then drive for a few minutes. Or dry in the shade. This will clean up the water that has just been glued to the car.

Cake Cabinet

1. High quality imported Compressor energy saving and low noise.Compressor brand Embraco and Danfoss is available for customers to choose.
2. Toughened heated glass, anti condensation and energy saving and good visual effect.
3. LED light in illumination, avoiding glaring.
4. Independent electronic board and cooling system, can be easily taken out for maintenance or replacement.
5. Environment-friendly CFC-free Refrigerant R134a or R404a.

Cake Cabinet,Small Display Cabinet,Cake Display Cabinet,Cake Glass Display Cabinet

ShanDong XiMaiD Commercial electrical appliance Co. LTD , https://www.shandongximaide.com

Posted on