![<?echo $_SERVER['SERVER_NAME'];?>](/template/twentyseventeen/skin/images/header.jpg)
1.Before the centrifuge is running, cut off the power supply and loosen the centrifuge brake first. You can turn the drum by hand to see if there is biting.
2. Check other parts for looseness and abnormal conditions.
3. Turn on the power and start it by turning clockwise (usually about 40-60 seconds from stationary to normal operation).
4. Normally, after each equipment arrives at the factory, it must be idle at about 3 o'clock. It can work without exception.
5. Keep the material as evenly as possible.
6. Must be specially operated, the capacity must not exceed the rated capacity.
7. It is forbidden to run the machine at a speed so as not to affect the service life of the machine.
8. After the machine is started, if it is abnormal, it must be stopped and checked. If necessary, it must be removed and repaired.
9. When the centrifuge is working at high speed, it is not possible to use the body to touch the drum to prevent accidents.
10. The mesh number of the filter cloth should be determined according to the size of the solid particles of the separated material, otherwise the separation effect will be affected. In addition, when the filter cloth is installed, the filter cloth seal ring should be embedded in the drum seal groove to prevent the material from entering.
11. In order to ensure the normal operation of the centrifuge, rotate the parts every 6 months after the oil maintenance. At the same time, check the running lubrication condition of the bearings, whether there is wear phenomenon, whether the components in the brake device are worn or not, and seriously replace them; whether the bearing cover has oil leakage or not.
12. When the machine is used up, it should be cleaned and the machine kept clean.
13. Do not separate non-anti-corrosion centrifuges from highly corrosive materials; in addition strictly follow the equipment requirements and regulations; non-explosion-proof centrifuges must not be used in flammable or explosive environments.
Fiber Laser Metal Sheet Cutting Machine
It can cut all kinds of metal plates, pipes, and is mainly used for rapid cutting of stainless steel, carbon steel, manganese steel, galvanized sheet, various alloy plates, rare metals, etc.
Widely used in: kitchen appliances, sheet metal chassis cabinets, mechanical equipment, electrical equipment, lighting hardware, advertising signs, auto parts, display equipment, various metal products, sheet metal cutting processing and other industries.
Principle of fiber Laser Cutting Machine
The fiber laser cutting machine adopts the international advanced fiber laser to output a high-energy density laser beam, and focuses on the surface of the workpiece, so that the area irradiated by the ultra-fine focus spot on the workpiece is instantly melted and vaporized, and the spot illumination is moved by the numerical control mechanical system. Automatic cutting is achieved. It is a high-tech equipment integrating advanced fiber laser technology, numerical control technology and precision mechanical technology.
Fiber laser cutting machine features
1. Can blow air to cut various metal sheets;
2. High performance, imported original packaged fiber laser, stable performance and long service life;
3. High speed, from efficiency, the speed of cutting thin plates can reach tens of meters per minute;
4. The laser is maintenance free;
5. The cutting edge has good quality, small deformation, flat appearance and beautiful appearance;
6. Adopting imported guiding transmission mechanism and servo motor, the cutting precision is high;
7. It is free to design all kinds of graphics or text for instant cutting, which is simple, flexible and convenient.
Fiber Laser Cutting Machine,Fiber Laser Cnc Cutting Machine,Commercial Laser Cutting Machine,Ccd Camera Laser Cutting Machine
Shandong Buluoer Intelligent Technology Co., Ltd. , https://www.buluoermachine.com